3/8 in. x 1/2 in. Connector
Overview
The Anderson Metals 00088-0608 is a brass drilled-through tank connector linking a 3/8 in. compression tube to a 1/2 in. male NPTF thread. Because the body is drilled fully through, it doubles as a tank or bulkhead fitting where the male thread passes through a wall and is locked with a nut. The 0.87 in. hex eases wrenching; threads are 9/16-24 on the compression side and 1/2-14 on the pipe side.
Technical Specifications
| Part Number | 00088-0608 |
| Connection 1 | 3/8 in. Compression |
| Connection 2 | 1/2 in. Male NPTF |
| Fitting Type | Connector (drilled-through tank) |
| Thread Size | 9/16-24 x 1/2-14 |
| Hex Size | 0.87 in. |
| Pressure Rating | 200 psi |
| Temperature Rating | -65°F to 250°F |
Materials of Construction
| Body | Brass |
| Compression Nut | Brass |
| Sleeve / Ferrule | Brass |
| For Use With | Copper, aluminum, thermoplastic tubing |
Typical Applications
The drilled-through design suits tank and reservoir penetrations where a 3/8 in. tubing run feeds through a wall to a 1/2 in. female NPT port or is secured by a back nut: fuel-oil tanks, day tanks, oilers, and equipment hookups. It also serves as a standard 3/8 in. tube to 1/2 in. male pipe connector in low- and medium-pressure work.
Cross-Reference and Interchange
Replacing a competitor part with this 3/8 in. compression x 1/2 in. male NPT brass connector? Match the tube size, the male NPT thread, and confirm whether you need the drilled-through (tank) version, or send us your part number and we will confirm the interchange.
Sizing and Installation Resources
- Compression Fitting Sizing Chart
- NPT Thread Tightening: Turns Past Hand Tight
- Teflon Tape vs. Pipe Dope
- Bulkhead Fitting Installation Guide
FAQ
What does drilled-through mean?
The body is bored fully through both ends, so fluid can pass and the male thread can extend through a tank wall and be secured with a nut.
Does it include a bulkhead nut?
No. The connector itself is supplied; provide a 1/2 in. NPT lock nut and gasket for tank-wall mounting.
Should I seal the NPT thread?
Yes, use PTFE tape or pipe dope on the 1/2-14 male NPT thread.
What is the working pressure?
200 psi for low- and medium-pressure service.
WARNING: This product can expose you to chemicals including lead, known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.