5/32 in. x 1/8 in. Push-In x Male NPT Swivel Branch Tee
5/32 in. x 1/8 in. Push-In x Male NPT Swivel Branch Tee
Overview
The Midland 20109 is a brass push-to-connect swivel male branch tee joining two 5/32 in. push-in tube ports to a 1/8 in. male NPT swivel run. The repositionable swivel thread lets you orient the branch after the threads are seated, which is ideal for tight instrumentation and pneumatic panels. Brass construction handles air, water, oil, and light gas service from -10°F to 200°F.
Technical Specifications
| MPN | 20109 |
| Fitting Type | Swivel Male Branch Tee |
| Tube Size (x2) | 5/32 in. Push-to-Connect |
| Thread Size | 1/8 in. Male NPT Swivel (1/8-27) |
| Hex Size | 0.37 in. |
| Length | 1.61 in. |
| Temperature Rating | -10°F to 200°F |
Materials of Construction
| Body | Brass |
| Connection | Push-to-Connect collet and o-ring seal |
Typical Applications
Used in pneumatic control circuits, instrumentation air lines, and small-bore fluid manifolds where a branch must tee off a run line. The push-in ports accept 5/32 in. OD tubing for fast, tool-free connections, while the swivel NPT leg threads into a port or bulkhead and rotates into alignment.
Cross-Reference and Interchange
This brass swivel branch tee cross-references to these competitor and industry part numbers: 272PPS-2.5A, 272PPS-2.5A-Y, 72PCS-5/32-2, AQ72-PS-5/32X2, D7072S-5/32A, DQ72PS-5/32X2, PC72SW-2-1/2A, PTC72S-5/32A, QPLS72-532-2, W172PL-5/32-2. Replacing one of these? Match nominal size, connections, and rating, or send us your part number and we will confirm the interchange.
Sizing and Installation Resources
- Push-to-Connect Fittings Selection Guide
- NPT Thread Tightening: Turns Past Hand-Tight
- Pipe Size Reference Chart
- Teflon Tape vs. Pipe Dope
Frequently Asked Questions
What tube size does the 20109 accept?
Both push-in ports accept 5/32 in. OD tubing; the threaded leg is 1/8 in. male NPT.
Can the branch be repositioned after install?
Yes. The swivel NPT thread lets you rotate the tee into final alignment after the threads are seated.
What is the temperature rating?
-10°F to 200°F in brass.
Do I need thread sealant?
Apply PTFE tape or pipe dope to the male NPT leg; the push-in ports seal on the o-ring and need none.
WARNING: This product can expose you to chemicals including lead, known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.